Bobby Hart LRT fit dilemma

Hi there,
I am having an issue fitting a Hart LRT stock from Stocky's to a Savage 10FP, and could use a little insight. For the most part, the stock is a drop in fit. I cleaned up the inletting just a bit so that the rear pillar would fit flush in the trigger guard recess. Fitting the triggerguard itself proved to be a little more difficult.

http://i1135.photobucket.com/albums/...x/DSCF1606.jpg

This is my triggerguard, the raised area in the front will not allow the guard to fit into the inlet flush with the stock.

http://i1135.photobucket.com/albums/...x/DSCF1610.jpg

This configuration results in the rear action screw being about .2 or so too short.

http://i1135.photobucket.com/albums/...x/DSCF1611.jpg

From the LRT page on Stocky's website:

http://i1135.photobucket.com/albums/...triggerfit.jpg

Before I realized that the above said LRV, I went ahead and ordered a mod 12 triggerguard from the savage parts department. I received part #105417, which looks good on the depth, but not so much on the length.

http://i1135.photobucket.com/albums/...x/DSCF1613.jpg

I was hoping that someone with prior experience with these stocks might provide me with the correct part number for a triggerguard. I've entertained the thought of getting a longer rear action screw from Brownell's, but I'd really rather buy the correct part, and have everything fit nicely. If you could point me in the right direction, I would really appreciate it. That being said, this stock is absolutely gorgeous. It's the Granite Grey color, but contains much more blonde than I anticipated, with some red streaks here and there, that make it look really sharp. Please pardon the awful pictures.

I'm just now finishing up on a Bobby Hart LRT build. I used Midway # 344648/Savage # 105928 and it fit very well. This is a stainless guard.

The trigger guards listed on Midway for a model 10 worked on mine
Jim Biggs of Northland Shooter Supply has them and he is one of our sponsers here and a great guy to deal with
He might be able to send you some longer screws also
I have made longer screws from socket head cap screws purchased at a harware store
1/4" x 28 threads 1 1/2" long were good for my Bobby Hart stock ( with a little trimming on the length)

Thank you very much for the replies, I'll get a hold of Jim at NSS ;)