...
Printable View
...
I loaded practice rounds for my department sniper rifle on my Dillon to include using the powder measure. At that time the rifle was chambered 7mm/08. I was fortunate to be able to attend a LE training course put on by the training staff at the 2nd Marine Division Scout Sniper School, Camp Lejeune NC. I needed 500 rounds for the course so loaded it on my Dillon with 168 grain SMKs. I had no problems shooting accurate all the way out to 1k while in the course. The course had us shooting moving targets at 800 yards. Use your Dillon, it won't let you down.
Nosler ammunition is ALL loaded on 550's.
NO ammo company of any significance weighs powder, it is all loaded by volume drops. So the FGGM and other "desirable" factory ammo doesn't weigh either, so, there is your answer.
That would depend on what you consider "precision reloading. My answer is NO. The Dillon powder measure is just as good as any other and that is not the deal breaker. The deal breaker is full length resizing cases on a press that that use a shell plate and not a shell holder. You cannot get a consistant shoulder bump when the die does not bottom out on something solid like a shell holder. With that being said, I have loaded hundreds of rounds on my Dillon 550 by starting with sized and primed cases and just loading powder and seating bullets. I size all the cases on a single stage press and prime by hand, that is the most important part that must be consistant. Then run them through the Dillon for final loading.
My self have a 550 that i load using the powder measure and not depending if loading test rounds or match rounds, also have a RCBS Rock Crusher "new" to load for my 300 blk AR using the Hornady die bushing kit making die change easy not losing my setup
....
Lee has a "quick-change" system on their presses, just can't recall the name of the system. But if you look, it will be obvious.
My 550 will dial in so close that I use it for all my plinking, practice and 3 gun loads. The only calibers I single stage anymore are my F class loads and a couple of the big Africans. I do keep an old turret press on the end of the bench for short runs and "here, try this data" stuff.
Also, I only use Dillion dies and measures, in the 550...
Paul
I am partial to the Redding T-7 press and have dies in four different turrets, whch makes swapping calibers very easy!
in practice, I run all the brass thrugh an operation before rotating the turret, prime with a hand-priming tool, and use a conventinal powder dispenser and weigh charges when I want to be sure of consistency.
...
I got a Forster Co-AX about 7 years ago and never looked back. Before that had tried several Lee and RCBS and Lyman presses.
Rumor has it that Dillons are good enough for minute of prairie dog...