Printable View
[img width=600 height=450]http://i1037.photobucket.com/albums/a451/phirebug/rifle1.jpg[/img]
[img width=600 height=450]http://i1037.photobucket.com/albums/a451/phirebug/rifle3.jpg[/img]
Thanks to everybody here for helping me out with it, especially Jim at Northlander and the folks at SSS.
No photos -- more than likely your file size is too large.
it shows up on mine? probably because i linked to another site i post on. do i have to put them up on photobucket or something? i couldn't find a way to upload them directly to the thread.
Yup use photobucket. Check out picture post 101 in picture forum.
that work?
Yep. Nice !! Welcome to the club
That is a fine looking rig. I really like that gun case too. Did you inlet the foam padding yourself? If so could you give details? thanks, Bill
Nice clean looking setup.....what caliber is it?
uj
it's .308 with a Shilen barrel.
I bought the pelican case at the px with blank foam already in it and just cut the outline of the rifle with a razor knife. if you go slowly it makes a nice clean edge.
What bolt handle is that? What stock>? We need details
very sharp
bolt handle, stock, and trigger are SSS
it's got a +20moa farrel base, swfa 16x scope and rings :D
the receiver and magazine assembly are from a model 11 i got on sale at dicks. i'm saving the factory barrel for a future product, and i'm going to use the tupperware stock to practice bedding before i do it for real on the sss stock.
i had originally intended to duracoat the receiver and barrel hk semi-gloss black, but i kinda did the way the two-tone came out.