what torque should I use

I took the plunge and purchased a .308 model 10 with the Choate stock from Cabelas. I think it's one of the lower end Choate stocks, but for my use it's fine for the moment. Maybe someday I'll upgrade to a McMillan. Anyway, If I want to adjust the Accutrigger, I need to remove the stock. No problem. When I replace it, what torque do I torque the two reciever bolts down to? Any ideas? Thanks....

I just hand tighten them as tight as possible with a screwdriver that has a allen bit attachment.

I'm not familiar with the stock but I usually start at 30 inch pounds for non-pillar bedded stocks and 40 inch pounds for pillars.