-
110E bolt head scoring
Hello. First post. I've recently received an older 110E in .270 thats in been in the family a long time. Started going through it. The forward action screw was rubbing the underside of the bolt head. The bolt stamping matches the receivers serial numbers. So they must be a matched pair. So can I replace just the bolt head? Do I even need to replace it? Ive got some good pics, just havent figured out how to post yet. Thanks!
-
Over time the stock material compressed allowing the screw to protrude into the the lug recess or the screw was too long when new. In either case you don't need to replace the bolt head, ether shorten the screw or have pillars installed of the correct length.
Bill
-
Bill, thanks for the reply. The wood stocks can compress that much? Thats amazing. I cut the screw down a bit to temp fix it. I'm planning to do a pillar bedding on it at some point.
-
Your good to go. scaring is unsightly but won't weaken the lug at all. it has been known to happen with scope base screws as well.
-
Pillar bed it and go have fun.
-
If your going to do the pillars, I wouldn't shorten the bolt. I would use a washer under the head. This will let you use that bolt after the pillars.
Leo