Some questions on Brass & Zinc Bulletson a CNC lathe I made a Brass one but are they
Hi
I just got back from the gun shop and their sold out of bullets so that really put a bummer on this week end :apologetic: target shooting. I thought !
I had read on the internet that you can use soft brass and zinc for bullets but i have no mold for lead ones so i did a program for the CNC for this one i made it take a little over 2 minutes total and i think it came out OK but i want a less radii and i need to go back a bit further also and do a boat tail also.
This one weighs right at 70 grains.
What your thoughts i have my scope set at 300 yard and was using varmint rounds 58 grains with a good grouping so i,ll try this one. Like i said it weight is 70 grains and i don,t know how well it will do by having that heavy radius.
But for the sinc i,m going to drill a .250 hole between 2 pcs of aluminum 4 " long and then turn them down a lot of work should see if i can buy zinc rod.
So whats your opinion on the lesser degree of a radius
O ya the bullet measures .2425 by .850 i really did,t want to go with 243the one i took apart was .2425 but ot could of been crimp t tighter
Thanks for looking
https://scontent-b-ord.xx.fbcdn.net/...c1&oe=535D20E1