My Savage 12 ejector / ejector spring is no longer kicking the brass out of the chamber - Can I purchase these parts online somewhere or should I give Savage a ring?
Printable View
My Savage 12 ejector / ejector spring is no longer kicking the brass out of the chamber - Can I purchase these parts online somewhere or should I give Savage a ring?
The ejector, spring and retainer pin are cheapest from Savage. I bought several each of all the bolt head parts just to have spares when I needed them.
As Texas said Savage is an option.
Other options are Midway, Brownells, and Gun Shack ( one of our forum sponsors)
There are certainly more vendors than what I listed
I have to ask: are you sure that the spring is broken and not that the ejector is stuck due to trash/grit?
do the single shot guys remove the ejector?
Quote:
Originally Posted by JW
To be honest I'm not sure. I guess since it's not working very well I could just take it apart and find out. Can't get any worse, right?
Which is the correct spring for a 12?
https://www.midwayusa.com/product/19...g-all-calibers
or
https://www.midwayusa.com/product/13...g-savage-110ba
The top one (all calibers)Quote:
Originally Posted by LVLAaron
If the ejector is sticking up above the bolt face, try pushing it dowm and see if it springs back up
If is does, the ejector probably is not the issue
You might need to take a look at the extractor
Thanks. Pretty certain it's the spring. Extractor is fine. Ejector spring is pretty limp.Quote:
Originally Posted by JW
I have removed the ejectors from all my Savages that see only bench action. Got tired of chasing my carefully prepared brass all over tarnation, and also tired of fishing brass out of the action that has flipped backwards. Not knocking Savages, but my 308 is the only model 12 action I have that reliably ejects, so it's for hunting.Quote:
Originally Posted by gchellin
Without the ejector, the brass stays attached to the bolt head upon retraction, and I just pick it out and place it back in the box, nicely sorted and free of dirt.
Quote:
Originally Posted by Texas10
On my 12, I have no problem quickly opening the bolt and catching the brass in my hand. :) - On that note I've got a couple of guns with them removed.
Quote:
Originally Posted by LVLAaron
Both are right. The 110ba spring is stronger and will kick the brass out farther.
With my 223 I am able to do that, catch the ejecting case mid-air as I fling the bolt back, but it still tends to leave a case on top of the magazine from time to time, usually facing backwards. The 223 and 308 case are not significantly "over-bore" in design like the 22-250 and 6mmBR, where you have a big, fat case with a small neck, which contributes detrimentally to the ejection process.Quote:
Originally Posted by LVLAaron
OP- if you'll pm me your address, I'll send you one of my spare springs, with ejector if you like. I also have two modified ejector kits that will improve ejection, for sale if you prefer.