Re: B&C Duramaxx..... WTF!!!
you can make it fit, drill out the front pillar to a larger diameter and install a new pillar
Re: B&C Duramaxx..... WTF!!!
:-\ If you wanted a Duramax that bad why did'nt you check screw spacing before you bought the gun?
Re: B&C Duramaxx..... WTF!!!
Now, you are beginning to realize what us left handed folks have been dealing with all our lives.
uj
Re: B&C Duramaxx..... WTF!!!
Well I wanted a new 10FP and that's just how they come now! I didn't buy the gun for the stock, I just wanted the stock for the gun! I may try that making it fit though, where can I get a new pillar?
Re: B&C Duramaxx..... WTF!!!
If your planing on making it fit with a new pillar, and all else fails, you can make one from steel lamp tubing, I have herd of even using car brake line. But the lamp tubing works good, its all thread tubing, so there's plenty of outer surface threads for epoxy to get a good grip on. I used it on one of my 6BRs and its works great. Its also a little larger and that helps in alignment.
And you can also buy pillar kits, sort of a cut to fit kit. Doing this is not that big of a job, assuming your going to bed it anyway.
Mike.
Re: B&C Duramaxx..... WTF!!!
You can buy pillars from Stocky's for $11 or you can take the ones from the stock you have.
If it is a tupperware( the cheap stock) just heat up the area around the pillars with a hair dryer or heat gun and then tap them back through the stock. I have done it both ways, in a hurry drive them out, plenty of time buy new ones.
Re: B&C Duramaxx..... WTF!!!
You can use Rem 700 pillars also, same radius and screw hole.