I am trying to find out if there is a recommended or commonly used amount of torque for tightening the BAS. I have searched, but the only answer I have found is "tight" and "very tight". Does anyone use a certain setting?
Thanks
Bill
Printable View
I am trying to find out if there is a recommended or commonly used amount of torque for tightening the BAS. I have searched, but the only answer I have found is "tight" and "very tight". Does anyone use a certain setting?
Thanks
Bill
No torque setting required for BAS, just crank on it a bit.
Just nice and tight by hand.
No need to additional torque, the flange of the BAS should stop once it pinches the bolt handle to the bolt body.
Thanks Guys