Questions about pillar bedding
Somewhere, perhaps on this forum, I read an informative post, with several pics, about a pillar bedding job that involved brass lamp parts. The technique described involved using two parts for each pillar, the threaded tube cut to length, and a threaded cap into which the tube was screwed, enabling adjustment for the proper pillar height. Does anyone recall seeing that post, on this site or elsewhere? If so, please point me in the right direction.
Also, I have a question regarding the pillars to be used. Should they be just large enough to accommodate the action screws, or should they be larger, so as to avoid potential contact with the pillar itself?
Thanks everyone in advance for your attention.
