-
Trigger Job
While i'm waiting on my laminated stock to get here any day i started reading up on glass and pillar bedding which lead to lots of other good info including a tip to lighten up the trigger....replacing the factory spring with .040 (1mm) wire. my trigger has never been poor, maybe a little heavy, but crisp anyway. with doing nothing else but replacing the spring it is SOOOOO nice. felt too light, but i repeatedly bounced the butt stock off a rubber mat hard, slammed the stock with my palm, slammed the blot shut and no fires at first. came back to it again and after pounding on it very hard with my palm in the area of the trigger it did slip. so i backed the screw out a 1/4 turn and couldnt reproduce the misfire, but still have a fantastic trigger.
http://i47.photobucket.com/albums/f1...1978/photo.jpg
before and after materials
http://i47.photobucket.com/albums/f1...978/photo1.jpg
-
Mattd, i usually tape the safety in the fire position when bouncing the stocked rifle off the floor to keep it from setting itself in the safe position, then you don't know if it's working properly or not. i bounce mine on the linoleum or concrete flooring without the scope mounted and if it doesn't fire then i know it's safe to use.
make sure firearm is empty at all times when performing these tests!!!
-
I implement a secondary safe... I wont close the bolt until im ready to fire. It works for me.
-
-
Quote:
Originally Posted by
243LPR
Is that a paper clip?
Not anymore....
-
If the spring was made from a paper clip, it will not work long. Just long enough to be dangerous. Lack of tensile strength.
-
Not a paper clip....1mm galvanized steel wire. Altho that could easily be what paper clips are made of
-
I am afraid it will not hold up. Hope I am wrong. It looks too easy to shape. If so, it will lose its flex soon and be unsafe.
-
I found it easier to just buy 10 feet of music wire from here: http://howardpianoindustries.com/pia...0-lengths.html
-
Alas not all wire is equal. send me an envelope and I will send you one already shapped out of .040.
-
I could be wrong but the angle on that trigger does not look correct. If that has been altered, please correct it. With a light spring this could be dangerous. The two surfaces should be vertical and nearly parrallel. I modify the sear one the bolt/ trigger release part and just polish the trigger sear.
-
i haven't altered it and I've had it with the factory spring for more then 10 years. which 2 surfaces should be parallel? the sear and the ledge it rests against?
-
-
Mattd,
From your picture, I can see you've got too much screw engaged on your trigger job.
The picture of the wire you used for a trigger spring tells me that it's too soft. That also coincides with the excess screw engagement.
What you need is spring steel and a proper shape to it to maintain the setting you've chosen.
Soft wire will be dangerous.
Best regards
Three 44s
-
Spring steel or piano wire as said...
I busted a very small slide stop spring wire on my CZ... and someone recommended heavy fishing wire (solid, not stranded) leader (which I happened to have) that also has the correct properties. Works great...
