Can someone estimate how much it would cost to have a like new mcgowen barrel rechambered in 300 win mag from 30-06? Would I be better of selling it and buying a new one already chambered in 300?
Printable View
Can someone estimate how much it would cost to have a like new mcgowen barrel rechambered in 300 win mag from 30-06? Would I be better of selling it and buying a new one already chambered in 300?
It would probably run you about $125, depending on the smith. Far cheaper than purchasing a new barrel.
Great, thanks!
Now, next question. Where should I send it I am located in eastern kansas.
Personally I'd send it to Jim at Apache, but I'd contact him via email first to get an idea on his backlog.
apachegunworks AT gmail DOT com....
I'm not entirely 100% on this, but im thinking the mag calibers have the larger shank. I know the short mags do. Just FYI. Im not too concerned about it with my short mag, but I figured you might as well know
The 300WM came in both sizes.
That's what I said unless my terminology is wrong. When I say mag calibers, I mean magnum bolt face or larger, so calibers with a .540 or .590. By the way, the 416 rigby is not the parent case for the wsm or rum, but is for the lapua and larger weatherbys. The 416 rigby has the .590 base. I honestly don't what the parent case for those cartridges are. It's not anything belted or it wouldnt be a true parent case.
It will be going on a small shank long action mag bolt face, no worries there.
After doing a little looking, it looks like the WSM's were based on a new case design. I had always thought they were based on the Rigby. Your terminology is off a bit, your statement that "mag calibers have the larger shank" is just not accurate, and could potentially have someone order the wrong barrel for their build based on that. Magnum cartridges such as the 7mm Remington Mag, the 338 Winchester Mag, and nearly all of the other belted magnums have always been factory built using the small shank action, with few exceptions.
I tried this once and the nationaly recognized smith botched it up. The pilot does not reach the bore so the nose of the reamer is not supported. I would think the bore would have to be single pointed to get the pilot into the rifling/bore. I would be very interested in a real smiths opinion. Fred?
I see. But the WSMs and SAUMs do run large shank actions?? I just read that somewhere. I only looked it up because I was in the process of building my 7mm SAUM and I didn't know but a lot of people do it so its really kind of irrelevant to the OP. But for the sake of information, its nice to know.
Yes. And the reason is that with small shank actions, Savage found that upon firing, there was enough expansion of the chamber walls with the larger bodied cases to cause the brass to also expand. The chamber walls would then return to its original size, but the brass had expanded enough to cause difficult extraction. Increasing the chamber wall thickness only slightly alleviated the problem for the most part.
The two WSM rifles I have built on small shank actions have not displayed any difficulty exrracting fired cases. But I don't run proof loads through them, either.