Will a staggered Feed fit?

Printable View

02-19-2016, 10:24 AM
idunham

Will a staggered Feed fit?

Will a 110 staggered feed blind mag (Internal) fit into a stock made for a 110 center feed (Internal)?
02-29-2016, 08:21 AM
GaCop

You will probably have to do some mods in the mag well but it should be doable.
03-06-2016, 03:18 AM
yew plucker

Screw spacing is the key. My 10 Short action is a blind/staggered with 4.27 screw spacing. I find that stock options are limited. A Bell and Carlson 2999 works.
03-06-2016, 12:55 PM
geargrinder

110 means it should be a long action. Screw spacing is the same on all long actions.

Should fit fine. Mod would be needed to use a centerfeed setup in a stagger feed stock.
03-06-2016, 01:00 PM
Robinhood

Quote:

Originally Posted by geargrinder

110 means it should be a long action. Screw spacing is the same on all long actions.

Should fit fine. Mod would be needed to use a centerfeed setup in a stagger feed stock.

Quote:

Originally Posted by GaCop

You will probably have to do some mods in the mag well but it should be doable.

This.
03-06-2016, 01:18 PM
wbm

Quote:

Originally Posted by idunham

Will a 110 staggered feed blind mag (Internal) fit into a stock made for a 110 center feed (Internal)?

Oops.
03-06-2016, 02:28 PM
geargrinder

Quote:

Originally Posted by wbm

Yes. Have done a couple of conversions. You can either cut a notch for the center feed magazine clip in the stagger feed stock....I used a Dremel tool...or fit the center feed magazine in the stagger feed stock so that it is set at the correct height for proper feeding....this takes a bit more work and results in a "semi permanent" alteration....I did not like it nearly as well as cutting the notch in the stock. Had a "How To" with pics on the forum at one time but it is long gone....just tinker with it a bit and you will figure out the best way for you.

I think he's going the other way. Putting a stagger feed in a centerfeed stock. It already has the notch that won't be needed.
03-06-2016, 04:35 PM
wbm

Yep. I think so too.....thanks for the heads up.
03-07-2016, 01:28 PM
Txhillbilly

You will need to lengthen the front of the magwell area in the stock. It's easy to do with some wood chisel's and a Dremel tool. I used a Boyd's centerfeed stock on my 110 staggered feed action when I built my 6.5-06.

You can see the amount of stock material that will need to be removed in this picture-

http://i999.photobucket.com/albums/a...ps2eebec96.jpg

Here's a picture of the stock after I fixed it-

http://i999.photobucket.com/albums/a...ps9ad50d50.jpg