Once the cocking button is removed, the inner sleeve and firing pin assembly fall right out of the rear of the Bolt Body.
This is the Bolt Head, Front Baffle, Spring Washer, and Retention Pin removed. After the firing pin assembly is removed from the rear of the bolt body, the Retention Pin can be pushed out and the rest disassembles as shown.
Reassembly is just the reverse of the steps above.
To re-install the BAS once you are to that point, move the Cocking Button to the position indicated by the arrow. Then thread in the BAS about 3 turns only.
Then slide the Cocking Button as indicated from the Purple Arrow to the Orange Arrow. You can use your thumb or the corner of a counter, table, or work bench to apply pressure to move the button. Once the button is in place at the orange arrow then just use your 1/4" allen to screw the BAS in the rest of the way and tighten hand tight.
That's it. Bolt tear-down and reassembly made easy.
DISCLAIMER: The information contained in this article and/or the attached video are for educational purposes only. Should you choose to use this information to alter or modify your firearm you do so of your own accord. In doing so you accept full responsibility for any adverse affects, damages, injuries and/or death that may occur as a result. |
vBulletin Message