• Axis Trigger Spring Mod

    This information is provided for educational purposes only. Application and use of the information below is done so at your own risk. As always, be careful and check the safety to make sure it functions correctly after wards by doing the drop test. Then cock the rifle (unloaded of course) and try to pull the trigger with all the force you can with the safety on.

    This is the factory spring you can see how they made a tighter coil so the spring would stay in the hole and keep the spring where it needs to be.



    Here is the under side of the trigger with the tension pin installed. I just used chanl locks to press the pin in flush with the bottom of the trigger.



    Then I just cut the tension pin down with a hack saw. Just make sure you cut it shorter then the safety screw. Again the only reason you use the pin is so the spring won't pop/fall out.



    This is what it will look like with the new spring.



    And this is what it looks like all back together.


    The preceding information and photo's were sourced from dmpowder's post on the Predator Masters Forum and have been re-posted here with his permission.

    DISCLAIMER:
    The information contained in this article and the attached video are for educational purposes only. Should you choose to use this information to alter or modify your firearm you do so of your own accord. In doing so you accept full responsibility for any adverse affects, damages, injuries and/or death that may occur as a result.



  • Help support Savage Shooters by
    joining Team Savage today!


    Upgrade to Team Savage