Where is the best place to buy a 110 long action Picatinny type scope base?

[skoger]

I have several older 110 long action, flat back, round front recieves, looking for a long one piece picatinny scope rail, where is the best place to buy 2-3? All help appreciated.

[geargrinder]

Midway sells the EGW one piece rails that I have on most of my rifles.

[helotaxi]

Midway and SWFA both sell the EGW. SWFA has the Weaver base which has a recoil lug and runs $10 cheaper.

[geargrinder]

Midway and SWFA both sell the EGW. SWFA has the Weaver base which has a recoil lug and runs $10 cheaper.


Midway has those too. I've been very tempted to buy one. The look lower like the EGW HD's.

[cqh1111]

I just ordered two of the Weavers from opticsplanet. They are the cheapest and have free shipping.

[helotaxi]

The Weaver might be a little bit lower. I didn't mic it before I installed it to compare to the EGW that it replaced. The replacement was to go to a 20MOA base not because there was anything wrong with the EGW.

[MatthewUSMC8791]

Murphy Precision is a awesome base... http://murphyprecision.com/
IMO its better then KF...... CS is better too....JMO

[GaCop]

Very nice but definitely not cheap!

[TonyBen]

Murphy Precision is a awesome base... http://murphyprecision.com/
IMO its better then KF...... CS is better too....JMO


Looks like they only make bases for round tops, no round flats. Bummer!

[efm77]

I'm pretty sure the Weaver is only made for the round rear receivers too. I don't see any listed on their site for the flat backs. I ran into that problem with the EGW HD's, they're only made for the round rears as far as I can find.

[helotaxi]

What rings and scope are you planning to use? I have a long action with the square back and the EGW base is the only one that I found that would fit it in a 1-piece 1913/Weaver style rail. The problem with the EGW is that it is pretty tall. When coupled with my favorite rings (Burris Signature Zee; medium is the lowest height that they come in) the scope sits up higher than I like. I may end up going back to the Leupold style bases with the Signature rings on that rifle to get the scope lower again, even though I'm not really a fan of that style base.

[rc109a]

Bought the EWG 20MOA base. It was too high for my use. Now it is sitting in the desk drawer taking up space. I went with the Talley Ring mounts. For a one piece design, they are actually pretty good.

[MatthewUSMC8791]

Murphy does custom work as well, and its done right...He's definitely a straight shooter and gives you what you paid for, no BS... So don't waste your money on aluminium bases, go straight to steel.... only way to go...

[3fingervic]

I bought it direct from EGW.

http://www.egwguns.com/savage/savage-flat-back-picatinny-scope-mount/


P.S. I used Burris XTR's (Low).