Stock wrench?

[pizzabox]

What kind of wrench and/or tool is required to torque the accu-stock please? My rifle is a FCP-K .308

[ellobo]

I think what you need as a torque wrench that reads in inch/lbs. I assume your talking about the reciever retaining bolts and the accu-wedge screw. Midway USA and Brownells sells them. any good hardware or tool supply co. should also have them.

El Lobo

[Uncle Jack]

You might give this a look:

http://www.harborfreight.com/1-4-quarter-inch-drive-click-stop-torque-wrench-2696.html

uj

[Cycler]

You want a 1/4" square drive torque wrench as these typically cover the range of 0-60 inch-pounds since the spec for the Accustock bolts is 40 inch pounds. You also want a 5/32" hex bit as the stock bolts have allen heads that size. A beam-type of torque wrench is both less expensive and more reliable than a "clicker", particularly a cheap clicker.