removing trigger group

[druid w/stick]

Have model 12 with accutrigger. Was bought used and was spray painted. Want to redo, plus do a bedding job. Can complete trigger assembly be removed
without taking apart in pieces? If so, how does one go about doing this?
Greg

[trappst]

Push the cross pin out that holds the trigger bracket and sear. Just keep a finger or something over the sear spring as they have a nasty habit of flying off into infinity.

Re-assembly can be a bit tricky but nothing terrible.

[druid w/stick]

Thanks Trappst. I had read something like that here before , was'nt quite sure . Thanks for quick reply.
Greg

[MDHOGGER]

Another tip would to get yourself a small punch the same diameter or less than the cross pin to use as a slave. Insert it first through the trigger housing and then follow it back out with the cross pin. This will help in keeping things in alignment.