PDA

View Full Version : Mark I/II/93R: 900TR Diagram


feedramp
10-21-2009, 03:55 PM
Hello All,

I'm looking for a parts diagram (schematic) for a 900TR. Any help would be much appreciated. Thanks!
sharpshooter
10-22-2009, 02:50 AM
The 900Tr is basically the same as the pre-accutrigger MkII. The biggest difference is the stock and the fact that it was fitted for receiver sights.
feedramp
10-22-2009, 10:20 AM
The 900Tr is basically the same as the pre-accutrigger MkII. The biggest difference is the stock and the fact that it was fitted for receiver sights.


Thanks sharpshooter.

Do you know if Savage is still supplying parts for the Mark II? I assume (for the most part) these parts would work in a 900TR.
sharpshooter
10-22-2009, 11:42 PM
What parts are you needing?
feedramp
10-23-2009, 04:02 PM
What parts are you needing?


I just acquired a 98% 900TR. Knowing that is was discontinued, I wanted to have a few spare parts on hand if available: i.e. - extractor, sear, springs......
sharpshooter
10-23-2009, 11:28 PM
I wouldn't worry about parts like that till you need them. I can honestly say I can't think of any particular parts that are problematic to those rifles.
feedramp
10-24-2009, 02:29 PM
Thanks again sharpshooter. Would you (or anyone) happen to know of an adjustable butt plate that would fit the 900TR? I'm looking for something that's not too wide so that the length of pull will not drastically change.
sharpshooter
10-24-2009, 11:10 PM
Adjustable butt plates will have to be custom fit. Look in Brownell's, they offer several versions.