gzig5
12-23-2010, 10:34 PM
Hello,
I'm new around here but have had a Mod 10FP .22-250 for more than ten years, just haven't shot it much since leaving CA. I'm going on a ground squirrel shoot in April and am trying to get the rifle ready. I had put in a SSS trigger before I fired a shot and I bedded the tupperware stock and tried to stiffen the forend which is like a wet noodle. Worked pretty good and I got 10 shot groups under an inch at 100. So, I've aquired a Palma stock and will modify it to fit my action, maybe with a bedding block. To get to the point, I don't want or need a magazine but I will need a loading platform. Before I go through the trouble of making one, does anybody make a slim loading ramp that would not project outside the dimensions of the action? This is a stagger feed mag, and I did not see one on the SSS sit for this action. I'd probably epoxy or TIG it in place, or it could be mounted to the stock for that matter.
Greg
I'm new around here but have had a Mod 10FP .22-250 for more than ten years, just haven't shot it much since leaving CA. I'm going on a ground squirrel shoot in April and am trying to get the rifle ready. I had put in a SSS trigger before I fired a shot and I bedded the tupperware stock and tried to stiffen the forend which is like a wet noodle. Worked pretty good and I got 10 shot groups under an inch at 100. So, I've aquired a Palma stock and will modify it to fit my action, maybe with a bedding block. To get to the point, I don't want or need a magazine but I will need a loading platform. Before I go through the trouble of making one, does anybody make a slim loading ramp that would not project outside the dimensions of the action? This is a stagger feed mag, and I did not see one on the SSS sit for this action. I'd probably epoxy or TIG it in place, or it could be mounted to the stock for that matter.
Greg