View Full Version : Mark I trigger assembly torque
Gary Jordan
02-04-2024, 10:32 AM
On a Mark I FVT trigger assembly, is there a recommended torque on the hold down bolts ?
sharpshooter
02-04-2024, 05:27 PM
Basically not really, just hand tight.
Fasteddie01
02-05-2024, 10:52 AM
I'd suggest around 30 in-lb and maybe try 5 i-p lower if you want to keep good records of accuracy based on 50 or more measured 5-round groups. I use 25 on my B22 in synthetic stock and my CZ-455, so watch for 'crushed' wood in your stock. Even 20 might be all you'll need. An 'older stock' might already have all the 'crushing' done ?
sharpshooter
02-05-2024, 07:25 PM
I believe he was referring to the stand offs that hold the trigger bracket in place, not the action screws.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.