View Full Version : Anybody know....
tropicmaster
10-09-2009, 04:03 PM
where to get aftermarket bolt handles? I do not see any on any of the sponsor sites.
outlawkyote
10-09-2009, 04:16 PM
SSS has them and, last time I looked, they still had pictures of them on their sponcers page too.
tropicmaster
10-09-2009, 06:15 PM
Ahhhhh I never scrolled far enough down to see them. Still would not mind looking at others if anybody knows a source.
WaltherP99
10-09-2009, 07:13 PM
Kevin at Stockade Gunstocks makes one.
longshotCPL
10-10-2009, 02:54 PM
okay, here's a more specific one - what are the parts compatibility between the 10 and 110? for instance, can model 10 bolt handles fit the 110, since they have nothing at all to do with the chamber and length of action? there seem to be more handles for the 10 than the 110...
any other parts common between the two?
I think it is easier to list the parts that are not compatible, off the top of my head the only ones I can think of are:
Stock
Bolt body
Firing pin & spring
The magazine box & follower may be, for instance I have a 110 that started life as a .308 so it has the short magazine box cut out in the receiver. As far as I know everything else will fit either one. There are many folks here that are much more knowledgeable than I so I'm sure they will add to the list if I missed anything.
Bob
sharpshooter
10-11-2009, 10:02 AM
Bob pretty much summed it up, with the exception of 1 pc scope bases.
I knew I would miss something!
shelbyfan
10-11-2009, 06:07 PM
The one I have.
http://www.rimfiretechnologies.com/ProductDetails.asp?ProductCode=16006
http://www.rimfiretechnologies.com/v/vspfiles/photos/16006-2.jpg
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.