110 Long Action Small Shank receiver

[Jackster]

The thin bolt raceway on my receiver is bent to the point where the bolt binds. I've tried to bend it back but I think it's a complex bend (out and up), and there is no way I can see to grip it properly to bend it back. It's out of line by maybe 1/32 of an inch or so, but that's enough. I pulled the barrel, and, of course, the bolt is fine. Anybody have a "parts gun" or a spare action (stripped, or with trigger assby) they can part with?

[pdog06]

Did you happen to take the barrel off without using an action wrench? Have seen it happen to others when removing a tight factory barrel.
Also, the best way to go about this is to place a want to buy ad in out classifieds, as that is really the designated place for your post.