Stock screw spacer on a 16 Light Hunter

[goodkid1]

Hi Guys: I just did some trigger adjustment on my Light Hunter 16, and a "lipped sleeve" fell from the rifle when I separated the stock and action. Now I can't figure out where this little 1/2 inch hollow sleeve goes. Please be specific for this dummy. Which action screw uses it, the front or back screw (or even the weak little trigger guard screw? Does the "lip" end of the sleeve (spacer) face up (toward the scope) or down (toward the ground)? Thanks.... :)

[futurerider103]

How about a pic

Sent from my SM-G960U using Tapatalk

[jpdown]

Most likely was in front trigger guard hole to keep bolt head from crushing cheap plastic trigger guard from too much torque. Best fix is to replace plastic TG with SS, BBR metal trigger guard. Gun Shack among others sell them.

[Robinhood]

I agree with JPdown. Look at both action screw holes, it came out of one of them. The bore should be around 5/16"