NatureBoy
09-24-2020, 10:00 PM
Hey guys!
Long time lurker and not new to rifles....however inexperienced with Savage actions.
I have acquired a Savage 111 in 7 remmag and I have a few questions in regards to aftermarket stocks.
The rifle is a Detachable mag that is stagger-feed and it seems as if my stock options might as well be zero.
I was wondering if it would be possible to convert from the stagger-feed detachable magazine to a hinged floorplate?
My first assumption is that since it is a stagger-feed, I cannot...but I hope that I am wrong.
I apologize for my ignorance and I have searched but havent found the answer(s) and so if this has been done, please feel free to post the link for I do not mind reading.
A little information that may assist in this answer is:
I used to build long range rifles on (the other brands actions) and chamber/headspace the barrels to the actions after I blueprinted them. So, again, I am not new to rifles but just new to Savages.
Any help is greatly appreciated and I hope to get this rifle up and going with a decent stock so that I can start doing load dev.
Long time lurker and not new to rifles....however inexperienced with Savage actions.
I have acquired a Savage 111 in 7 remmag and I have a few questions in regards to aftermarket stocks.
The rifle is a Detachable mag that is stagger-feed and it seems as if my stock options might as well be zero.
I was wondering if it would be possible to convert from the stagger-feed detachable magazine to a hinged floorplate?
My first assumption is that since it is a stagger-feed, I cannot...but I hope that I am wrong.
I apologize for my ignorance and I have searched but havent found the answer(s) and so if this has been done, please feel free to post the link for I do not mind reading.
A little information that may assist in this answer is:
I used to build long range rifles on (the other brands actions) and chamber/headspace the barrels to the actions after I blueprinted them. So, again, I am not new to rifles but just new to Savages.
Any help is greatly appreciated and I hope to get this rifle up and going with a decent stock so that I can start doing load dev.