Single shot feed ramp for savage 12fv

[GameKing]

Anybody know where I may be able to find one if these? I saw older threads suggesting Kinney and SSS. But I had no luck on either website

[jpx2rk]

http://www.sharpshootersupply.com/

I printed out the order form and mailed a check for some a couple yrs ago, came in the mail.

[tobnpr]

Score High Gunsmithing

http://scorehighgunsmithing.com/

[mnbogboy2]

7377
Make your own....a few minutes on the table saw makes these blanks. Can use hardwood or softwood. This one was a 2x4 scrap. Final fitting into mag well, then sand the feed groove to suit. Finish to your choice.
Bolt picks up every round and the slope of the feed groove makes 100% feed with any bullet type.
Easy peasy.

[Fuj']

I've seen magazines with a tig welded ramp.

[mnbogboy2]

I've seen magazines with a tig welded ramp.

Hey Fuj, great idea, never thought of that, could easily fashion something for the C.F. blind mags like the OP' s 12fv. Maybe even silver solder it in place.
The old stagger feed mags could be replaced by a 16ga aluminum plate slid in the slots from side.
Lots of ways to skin this cat.