Spudgun
07-10-2020, 08:52 AM
I got the same problems too.
I have a model 12 F/V in 6.5 CM and ejects every time. Now my 110 that I re-barreled in 6mm CM, Will drop the case in the chamber about 80% of the time. Replaced the ejector, and extractor with the Kinney's extractor kit but still drops the cases when slowly extracting the bolt.
Same brass in both rifles (Starline).
I think my issue may be the magazine causing the ejection issues.
I only single feed my shots so I modified the mag and took out the spring and follower in the mag and put a piece of stiff foam in the mag so that I could drop a round in and feed into the chamber.
Upon further inspection I think maybe the lips on the mag are catching the case when I slowly slide the bolt back and knock it off the extractor.
Going to try to rework that area.
Anyone else got ideas???
I have a model 12 F/V in 6.5 CM and ejects every time. Now my 110 that I re-barreled in 6mm CM, Will drop the case in the chamber about 80% of the time. Replaced the ejector, and extractor with the Kinney's extractor kit but still drops the cases when slowly extracting the bolt.
Same brass in both rifles (Starline).
I think my issue may be the magazine causing the ejection issues.
I only single feed my shots so I modified the mag and took out the spring and follower in the mag and put a piece of stiff foam in the mag so that I could drop a round in and feed into the chamber.
Upon further inspection I think maybe the lips on the mag are catching the case when I slowly slide the bolt back and knock it off the extractor.
Going to try to rework that area.
Anyone else got ideas???