CIP length bottom metal and inletting for it

[coance]

I am starting a 300 PRC build with a old flat back 7 mag action and will need a new stock and Bottom metal that will accommodate the long round.
I had it all figured out but sadly Mr Allen from CDI Gunworks has past and now I am starting over.
Any and all ideas or comments are welcome

[J.Baker]

Passed as in passed away, or passed as in didn't want to do it?

[coance]

Passed as in passed away

[Lowholer]

I am in the same boat.CDI was going to inlet my new 300 win mag with there metal and aic mag set up.I have looked around and have not found any body who does savage rifles Post it up here if you locate some one please.

[coance]

I have a local Smith who has told me he could do it. I bought a Choate tactical stock and a spare center section for him to practice on. I also have a Savage 338 Lapua stock that he can measure and use as a guide. I haven't had it done yet so cannot tell you how it looks .

[Orr89rocz]

Sorry to bump a older thread but was cdi a one man shop? So they no longer do it? Can you still buy the cdi products?

[coance]

My understanding was that it was a one man show. I have not tried to contact them since I was told he had passed