borg
10-13-2010, 08:53 PM
I made a list of all the things that are more annoying than getting a case stuck in your full length sizing die:
I think that hits all the high points.
I managed to get it unstuck. It was a .223 case that I didn't wedge in too tightly, having learned my lesson early on with a .30-06 case that was so tightly bound I had to buy a new die from the manufacturer. (Long story, but I digress.) I had decent success with the RCBS extractor kit that I originally bought when I attempted to remove the .30-06 case. By "decent," I mean that I removed the case but bent the decapper pin in the process. Since I now consider myself an expert on the process, I thought I would share a few tips:
1. Do not, under any circumstances, get a case stuck in a full-length sizing die.
I think that hits all the high points.
I managed to get it unstuck. It was a .223 case that I didn't wedge in too tightly, having learned my lesson early on with a .30-06 case that was so tightly bound I had to buy a new die from the manufacturer. (Long story, but I digress.) I had decent success with the RCBS extractor kit that I originally bought when I attempted to remove the .30-06 case. By "decent," I mean that I removed the case but bent the decapper pin in the process. Since I now consider myself an expert on the process, I thought I would share a few tips:
1. Do not, under any circumstances, get a case stuck in a full-length sizing die.