PDA

View Full Version : Edge Bolt Disassembly



frazer
10-08-2010, 09:24 AM
Does anyone have instructions or pictures on how to disassemble the bolt for a Savage Edge? I would like to see what parts are interchangeable between the other savage bolt action models.

82boy
10-08-2010, 10:32 AM
I will save you the trouble.
The bolt head is interchangeable, and the rest has nothing in common with the 110/10 series rifles. The internals are closer in design to a 220 shot gun.
The bolt comes apart like any savage rifle.
This is a exploded view of a Edge bolt.
http://i34.photobucket.com/albums/d145/82boy/boltdisasembled.jpg

thirty06
10-08-2010, 01:57 PM
Are the bolt heads and baffles the same as the 110 or 10?

82boy
10-09-2010, 12:13 AM
The Edge doesn't have a "rear" baffle, it has a coking ramp built into the back of the bolt handle, between it and the cut in the back of the receiver, this primarily extracts the case. As stated before the bolt head is the same. The front baffle is slightly different, not sure if they interchange.(I dont see why not.) As you can see in the picture the front baffle has a set cut in it to allow the bolt to travel further toward the rear.

2ndchance
02-24-2011, 02:56 AM
Does anyone know if the bolt handle is interchangeable with the 10/110? I like the larger tactical bolt handles.

82boy
02-24-2011, 10:53 AM
Does anyone know if the bolt handle is interchangeable with the 10/110? I like the larger tactical bolt handles.


Nope, no even close.

rocket35
04-26-2011, 08:25 PM
I was looking at the bolt on an Axis this past weekend, and there wasn't the standard allen wrench type bolt at the end. Is the picture you posted of an Axis / Edge, or a standard savage?

Slim Jim
04-26-2011, 09:25 PM
I was looking at the bolt on an Axis this past weekend, and there wasn't the standard allen wrench type bolt at the end. Is the picture you posted of an Axis / Edge, or a standard savage?


Make certain there is no cartridge in the chamber. Put the bolt in the rifle and cock it. Dry fire and then check the back of the bolt. Should be 1/4" Allen head to loosen it. Take bolt out of rifle and finish unscrewing it by hand. This is on an Edge bolt, should be the same on the Axis ?? Good luck.

Mike

rocket35
04-27-2011, 11:45 AM
Thank you, it must have been that the bolt was out. It makes sense now.

Frank44
10-09-2011, 06:51 PM
I can't find an Allen screw anywhere on the back of the bolt on my Savage Edge. How do I get the back cap off?
Frank

82boy
10-09-2011, 10:52 PM
I can't find an Allen screw anywhere on the back of the bolt on my Savage Edge. How do I get the back cap off?
Frank


de-cock it.