JakeH556
07-20-2018, 02:14 PM
Hello all,
First off... I did look through the FAGs for this issue (not saying I read ALL of them, but I didn't see this question) and this isn't the typical 110 mag conversion question.
I am trying to literally convert my 110 that already takes mags, to take standard 110 mags instead of the garbage "Axis" mags.
The specific model is the "110 Brush Hunter" as far as I can tell, its a weird hybrid rifle that has a 110 barreled action and Accutrigger, in a modified generic Axis stock that takes the Axis mags with the plastic hook release instead of the push release that is in the rifle like my older model 110.
I am interested in the cheapest solution, I know that I can get a Boyds stock and order the bottom metal and trigger guard from Savage... But at over half the cost of the rifle that seems a bit silly?
What I would like to do is make this https://www.ebay.com/itm/253746314012 fit in my existing stock... Has anyone tried this? I am not opposed to heavily modifying the Tupperware stock, but I was hoping I could just drill-out the front action screw hole?
Any input is appreciated, and thanks for taking the time to read my post! I can put some pictures up if that would help get an idea of my rifle's current weird setup...
First off... I did look through the FAGs for this issue (not saying I read ALL of them, but I didn't see this question) and this isn't the typical 110 mag conversion question.
I am trying to literally convert my 110 that already takes mags, to take standard 110 mags instead of the garbage "Axis" mags.
The specific model is the "110 Brush Hunter" as far as I can tell, its a weird hybrid rifle that has a 110 barreled action and Accutrigger, in a modified generic Axis stock that takes the Axis mags with the plastic hook release instead of the push release that is in the rifle like my older model 110.
I am interested in the cheapest solution, I know that I can get a Boyds stock and order the bottom metal and trigger guard from Savage... But at over half the cost of the rifle that seems a bit silly?
What I would like to do is make this https://www.ebay.com/itm/253746314012 fit in my existing stock... Has anyone tried this? I am not opposed to heavily modifying the Tupperware stock, but I was hoping I could just drill-out the front action screw hole?
Any input is appreciated, and thanks for taking the time to read my post! I can put some pictures up if that would help get an idea of my rifle's current weird setup...