Help with putting Accutrigger back into model 11

[JimD]

I have seen lots of stuff on line but no help with reinstalling the accutrigger back into a model 11 in 7mm-08 with the bolt release on the bottom by the trigger guard. K526 are the first letters to the serial. The problem is how to fit the small sear spring back into the trigger assembly to work. ;) There appear to be many versions but this one one has a spring with a small strainght arm and the other is longer with a slight bend in the end of the longer arm.

Anyone have some suggestions or pictures or diagrams on how to do t his and exactly where the long arm attaches?

Thanks, Jim

[Robinhood]

Jim, There is a counter bore on the side of the action where the sear/hanger pin goes through. The coil part of the spring goes in there. In this picture you can just see the end of one of the springs legs where most of the spring is hidden by the sear and the hanger.
https://images.duckduckgo.com/iu/?u=http%3A%2F%2Fi305.photobucket.com%2Falbums%2Fnn 215%2Fnandy_temp%2F20131002_142101.jpg&f=1

[JimD]

Thanks,

I looked at ?? utubes on install and remove the trigger and not one could show the spring set up.

Is there a trick to getting the piece in place with the spring pressure?

[Robinhood]

Thanks, Is there a trick to getting the piece in place with the spring pressure?

Manual dexterity......






0

[short round]

Trick. Use a punch or something about the size of the pin, to align everything. Insert pin pushing out alignment tool.