View Full Version : Working with some barrel venting
Blackthorn
02-17-2018, 07:45 PM
Decided I needed to vent the stocks on both my F-Class rifles. Trying two versions. The first one is a two slot. 3/8” grooves that are 3” long. The second version is three slots 5/16” grooves that are 1-3/4” long.. Layout was the toughest part to make sure the grooves were consistent. I think this will really help dissipate heat during strings.
4577
4578
65Whelen
02-18-2018, 09:45 AM
Looks good, nice job. I like the shorter slots, no particular reason just my preference. Did you also do the check piece?
Blackthorn
02-18-2018, 10:48 AM
Thanks. After doing both styles I'm kind of partial to the shorter slots myself.
Yes I did cheek piece also. It is a Warner Tool wheel. The short slotted stock has the same cheek piece set up.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.