Savage GRS scope mount suggestions

[Jonreimer]

Looking for info on bases and rings for Savage GRS. As you know this rifle has a picatinny rail. The scope is a Bushnell DMR with 50 mm objective. Who knows or has experience for the best low profile set-up?
Thanks!

[dfrosch]

Welcome to the forum Jon.

I use two piece bases from Warne, Weaver or Burris and Warne Maxima rings. The two piece bases are a little lower than full length rails. And, the Warne low 30mm rings will put a 50mm objective just a hair over a varmint profile barrel. There's no room for scope caps.

But your scope is a couple inches shorter and has a 34mm tube. Check your mounting length. If you have 5-1/2 to 6 inches, these are made from steel and will offer some mounting versatility, but the bell of your scope is going to be very close to your barrel nut:

https://www.midwayusa.com/product/665735/burris-2-piece-xtreme-tactical-scope-base-picatinny-style-savage-10-through-16-110-through-116-round-rear-axis-reversible-front

https://www.midwayusa.com/product/1592331554/warne-34mm-maxima-permanent-attachable-weaver-style-rings-matte

Good luck,
Dana

[penna shooter]

Welcome aboard....