Inletting a Boyd's right handed stock for left handed action??

[zr600]

Ok I had to order a Boyd's right handed stock for my left handed action because they didn't offer the left handed stock in a heavy barreled option they said this would be my best bet. Well now I got the bolt handle notch done it seems to fit good but when you snug down the action screws the trigger doesn't reset. If I loosen the actions reed then it works fine. What do u guys think I possibly have going on? Any help would be great.

[short round]

The trigger may be contacting the stock, check inside of trigger area. Most likely to find trigger contact where the wood screw is.

[zr600]

Wood screw for the trigger guard?

[short round]

Wood screw for the trigger guard?

The screw at the rear of the trigger guard, unless things have changed, is threaded for wood, holds trigger guard to stock.

[Txhillbilly]

It's easier to just order a LH stock and open up the barrel channel for the barrel. Takes 15-20 minutes to do with a piece of pvc pipe and sandpaper.

[Robinhood]

How old is the rifle?

[Nor Cal Mikie]

My guess is either right or left hand inlet, you would probably have problems. That's a small thing to correct.

[zr600]

Well when i ordered my stock they told me the left handed model didn't have enough wood on the sides to open it up for the barrel I had. They don't make a left handed stock that I wanted that had enough room to be opened up that's why I did what I did. I did get it all fitted now the back of the trigger was hitting were the screw comes up I put a little spacer u see the trigger guard and took some wood out of that area.

[foxx]

Yeah, they told you wrong.

You did well.

It;s not all that unusual to have to do some final fitting and/or inletting.

[sharpshooter]

Will they replace it when it breaks?