Just a thought

[Danatkins8605]

I noticed when I bought my flcp-sr that there is a plug or outline so to speak on the right side of the stock where the bolt handle would rest. This got me thinking I really like the b&c stocks for the price compared to say a manner, mcm or hs so could I buy a b&c stock and just use a router to cut out a bolt handle notch for my left hand action?

Sent from my VS995 using Tapatalk

[darkker]

Of course you can

[Danatkins8605]

Sweet

Sent from my VS995 using Tapatalk

[Robinhood]

And you can fill in the other side.

[J.Baker]

You can, but often times it will leave the stock weak in the wrist area which will likely lead to it cracking in that area down the road.

[Danatkins8605]

Even with an aluminum skeleton?

Sent from my VS995 using Tapatalk

[sharpshooter]

Even more so with an aluminum skeleton.

[Danatkins8605]

What if I fill in the right side

Sent from my VS995 using Tapatalk

[sharpshooter]

The fill adds no strength. Once the primary cut is made it compromises the integrity of the stock. It make no difference if it's wood, fiberglass, or a combination of such with an aluminum block, it is the smallest cross section of the stock and takes all the stress.