saskaguy
02-05-2017, 11:03 PM
I installed a rifle basix trigger a while ago on my 204 and it was working fine. Took it off when I bedded the front lug and then re-installed the trigger and it was working fine. When I dropped the barreled action back in the stock and tightened up the action screws that is when I ran into a problem. If I tighten it right down the rifle discharges when I am closing the bolt. It is almost like something is catching or rubbing. Not sure if I should maybe remove a little wood in the trigger area around where the sear is? any thoughts?