View Full Version : Size of ejector retaining pin hole
bigfish27
10-26-2016, 08:01 AM
What is the size of the ejector retaining pin hole. I think they should all be the same. But specifically for a 223. To much headspacing has roughened the interior of the hole.
Thank you
Marlin
drybean
10-26-2016, 07:47 PM
I have a spare ejector retaining pin a can measure if that helps
Robinhood
10-26-2016, 08:47 PM
Deleted: bad advice.
sharpshooter
10-27-2016, 12:53 AM
The retaining pin hole is .063". The ejector hole is .103", plus or minus .001".
Robinhood
10-27-2016, 06:30 AM
Thanks Fred. I glazed over that one. I do use a 1/16th pin punch on the retainer pin.
bigfish27
10-27-2016, 07:20 AM
Thank you Sharpshooter. Now i an order a reamer to clean up the hole.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.