View Full Version : 520 parts.
Plain old Dave
08-30-2016, 12:45 PM
Lifter spring, the early V-type
Slide lock release spring
Rear trigger guard screw
Action bar and pump handle. Or just the bar if they can readily be interchanged.
Cosmetics aren't important, as the gun is rough cosmetically.
Sent from my SM-J700T using Tapatalk
OkiMarine
08-31-2016, 12:03 PM
Dave,
I like these guys for the lifter springs: http://www.ebay.com/itm/Savage-Stevens-Springfield-520-Double-Leg-Carrier-Spring-520-132-/141383836803
and Numrich https://www.gunpartscorp.com/Manufacturers/SavageStevensSpringfieldFox-33479/Shotguns-40503/520-41348.htm for everything else.
I've seen action bars for sale on ebay and Gun Broker, they have to be riveted to the pump handle. You can unscrew the front metal cap to remove the wood and inspect the connection on yours. That's where you will find stress cracking.
Plain old Dave
08-31-2016, 12:18 PM
I think the action bar is good, no flexing, and the internal parts don't show the wear you'd expect from a well-used gun. Stored poorly, used very little .
Sent from my SM-J700T using Tapatalk
OkiMarine
08-31-2016, 01:29 PM
Have you figured out why you were having take-down problems, just crud?
Plain old Dave
08-31-2016, 01:34 PM
The back of the bar is warped.
http://uploads.tapatalk-cdn.com/20160831/de42050c1a3614623363a8787c51654b.jpg
Sent from my SM-J700T using Tapatalk
OkiMarine
08-31-2016, 03:25 PM
Yup...that is without a doubt your problem. I bet you could straighten it out under a large press, a trip to a machine shop may be worth a try.
Plain old Dave
08-31-2016, 10:45 PM
Got home and the tube cracked at some point or another and was brazed back together. You almost can't tell from the inside surface.
Sent from my SM-J700T using Tapatalk
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.