116 sear spring

[carpcop]

Gents , I need a sear spring for a 116 that I recently bought . Checked several supply houses - no luck yet . Any assistance will be appreciated . thanks , carp

[keeki]

Which trigger is it

[keeki]

This one?
http://i1211.photobucket.com/albums/cc438/keeki5/20160820_122233_zpsp60oyriq.jpg (http://s1211.photobucket.com/user/keeki5/media/20160820_122233_zpsp60oyriq.jpg.html)

[RC20]

Broken?

Acu Trigger or non acu trigger?

Acu has the blade in the middle of the trigger (silver thingy most likely)

[carpcop]

It's not an accutrigger . It is a coil spring . This rifle was made before 1995 I think . The serial # was not available on Savage's site , and they advised that they dont supply parts for rifles made before '95 (I think). I was bedding the stock and punched the pin on the trigger group -shot that spring behind my workbench somewhere.

[BillPa]

It's not an accutrigger . It is a coil spring . This rifle was made before 1995 I think . The serial # was not available on Savage's site , and they advised that they dont supply parts for rifles made before '95 (I think). I was bedding the stock and punched the pin on the trigger group -shot that spring behind my workbench somewhere.

Do you remember if it's 'legs' were at 180 or 90 degrees to each other and did it use a bushing in the coils? I have one with the 90 legs and one 180 that used the bushing. IIRC you can use the 90 either way. If you can't locate one shoot me a PM, I'll send you which ever you need.

Bill

[keeki]

It's just a coil spring, take one out of an ink pen and use it, if one isn't enough, use 2

[Robinhood]

This, There are the factory springs and there is the mod. Lots of you tube stuff.

http://www.huntinggearguy.com/wp-content/uploads/2013/03/factory-trigger.jpg

[BillPa]

It's just a coil spring, take one out of an ink pen and use it, if one isn't enough, use 2

He needed a sear 'torsion" spring, not a trigger reset-WOP coil spring. The non-AT factory triggers didn't use a coil spring anywhere. When he said " [I] punched the pin on the trigger group -shot that spring behind my workbench somewhere" I knew exactly what he launched! I'm sending him one sometime today or tomorrow.

[Zero333]

I lost one of those springs before. Never found it.

When Brownells had them in stock I ordered a few. In the meantime I made something from a bobby pin or something like that and it worked until I received the springs from brownells.

[big honkin jeep]

I lost one and made one out of some piano wire from the hardware store, Just wrapped it around a pencil and then clipped it to length. That was years ago and it's been working fine ever since.

[carpcop]

Gentlemen , Thank you very much for you help , and Bill , I really appreciate the spring . It is very nice of you to help me out .Thanks again , Scott