WV1951
08-12-2016, 10:03 PM
Having done some research, it seems the recommended torque for the 10-11-12 series synthetic stock front action screw setting should be 30-35(with some as high as 40) inch pounds, and the rear starting at snug and tightening a bit at a time until groups come together. Once you go too far, the groups will start to open.
My s-i-l re-torqued my 12FV from the factory setting(which was much less) to forty front and rear and my last few groups weren't as good. I have reset to 30 front and 20 rear, haven't shot yet, but hope to in the next couple of days.
For those 12FV owners that have played with this, is this a good starting point?
My s-i-l re-torqued my 12FV from the factory setting(which was much less) to forty front and rear and my last few groups weren't as good. I have reset to 30 front and 20 rear, haven't shot yet, but hope to in the next couple of days.
For those 12FV owners that have played with this, is this a good starting point?