Hand notch on the bottom of butt

[seth.allen726]

Has anyone cut into the bottom of the butt on a fcp hs stock? How much material do I have before I hit the hollow portion?

Sent from my HTCD100LVW using Tapatalk

[Robinhood]

2/32nds

[mscott71]

You won't be able to do it without filling the hollow area. I have cut several of them for adjustable cheek hardware and use bondo to fill the hollow cavity. I'm sure cutting to bottom would require the same.

[Robinhood]

Yep, It was late and I neglected the fill. It is thinner on the sides than the top and bottom. I responded to your other post.

[seth.allen726]

I called HS precision...they tell me I have about 1.5" of material between the bottom of the stock and the hollow point inside.

Sent from my HTCD100LVW using Tapatalk

[seth.allen726]

The salesmen lied...it's not hollow at all. There is foam inside and the shell is about 3/8".

Sent from my HTCD100LVW using Tapatalk

[bodywerks]

He didn't lie. It is hollow, in that there is an open cavity in it. Yes, the sides are about 3/8 think with a super dense foam like material. Top is about an inch. I thought bottom was about the same but 1.5" doesn't sound too far off either.