110 LA Stagger Feed to DBM?

[Woods020]

Hello all,

This may be a topic that has been discussed but I didn't see it. If so I apologize in advance. I picked up a LA stagger feed receiver, but I want to convert it to drop box for a build. I saw the CDI solution, but it's over $200. Is there a cheaper/better solution?

Thanks!

[WinnieTheBoom]

CDI is your best bet. If you do go that route, they will inlet your stock and install the hardware for free.

Also, be weary that there's a lip on S/F actions for the blind mag well to clip into... You may need to throw it on a mill and take it off if you're wanting to feed reliably through a DBM, and especially if you're wanting to load to mag length.