Finished my savage build

[phirebug]

http://i1037.photobucket.com/albums/a451/phirebug/rifle1.jpg
http://i1037.photobucket.com/albums/a451/phirebug/rifle3.jpg


Thanks to everybody here for helping me out with it, especially Jim at Northlander and the folks at SSS.

[hailstone]

No photos -- more than likely your file size is too large.

[phirebug]

it shows up on mine? probably because i linked to another site i post on. do i have to put them up on photobucket or something? i couldn't find a way to upload them directly to the thread.

[bobcat30]

Yup use photobucket. Check out picture post 101 in picture forum.

[phirebug]

that work?

[viper9696]

Yep. Nice !! Welcome to the club

[fatdaddy]

That is a fine looking rig. I really like that gun case too. Did you inlet the foam padding yourself? If so could you give details? thanks, Bill

[Uncle Jack]

Nice clean looking setup.....what caliber is it?

uj

[phirebug]

it's .308 with a Shilen barrel.

I bought the pelican case at the px with blank foam already in it and just cut the outline of the rifle with a razor knife. if you go slowly it makes a nice clean edge.

[Scalian]

What bolt handle is that? What stock>? We need details

[glockeyed]

very sharp

[phirebug]

bolt handle, stock, and trigger are SSS
it's got a +20moa farrel base, swfa 16x scope and rings :D

the receiver and magazine assembly are from a model 11 i got on sale at dicks. i'm saving the factory barrel for a future product, and i'm going to use the tupperware stock to practice bedding before i do it for real on the sss stock.

i had originally intended to duracoat the receiver and barrel hk semi-gloss black, but i kinda did the way the two-tone came out.