View Full Version : Finished my savage build
phirebug
07-04-2010, 12:11 AM
http://i1037.photobucket.com/albums/a451/phirebug/rifle1.jpg
http://i1037.photobucket.com/albums/a451/phirebug/rifle3.jpg
Thanks to everybody here for helping me out with it, especially Jim at Northlander and the folks at SSS.
hailstone
07-04-2010, 07:33 AM
No photos -- more than likely your file size is too large.
phirebug
07-04-2010, 08:00 AM
it shows up on mine? probably because i linked to another site i post on. do i have to put them up on photobucket or something? i couldn't find a way to upload them directly to the thread.
bobcat30
07-04-2010, 08:44 AM
Yup use photobucket. Check out picture post 101 in picture forum.
phirebug
07-04-2010, 09:23 AM
that work?
viper9696
07-04-2010, 10:14 AM
Yep. Nice !! Welcome to the club
fatdaddy
07-04-2010, 10:34 AM
That is a fine looking rig. I really like that gun case too. Did you inlet the foam padding yourself? If so could you give details? thanks, Bill
Uncle Jack
07-04-2010, 10:43 AM
Nice clean looking setup.....what caliber is it?
uj
phirebug
07-04-2010, 11:29 AM
it's .308 with a Shilen barrel.
I bought the pelican case at the px with blank foam already in it and just cut the outline of the rifle with a razor knife. if you go slowly it makes a nice clean edge.
Scalian
07-04-2010, 11:38 AM
What bolt handle is that? What stock>? We need details
glockeyed
07-04-2010, 12:10 PM
very sharp
phirebug
07-04-2010, 03:17 PM
bolt handle, stock, and trigger are SSS
it's got a +20moa farrel base, swfa 16x scope and rings :D
the receiver and magazine assembly are from a model 11 i got on sale at dicks. i'm saving the factory barrel for a future product, and i'm going to use the tupperware stock to practice bedding before i do it for real on the sss stock.
i had originally intended to duracoat the receiver and barrel hk semi-gloss black, but i kinda did the way the two-tone came out.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.