View Full Version : modifing stocks
brianlt21
06-19-2010, 03:47 AM
Has anyone ever modified a staggered feed stock for a center feed action and what all is needed such as action screw spacing but what about magwell opened up
rjtfroggy
06-19-2010, 06:21 AM
I have done a few for the long action and it isn't all that difficult.
Close the mag well up by roughly .225" and remove a little material in front of rear action screw so the "L" clip sits properly. If you want to make it more difficult than that bed the mag in place.
On a short action I would assume the same procedure is needed with the addition of filling the screw holes with real good epoxy and then redrilling to proper spacing.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.