mounting bolt schematic/ CAD drawing

[aaronllewellyn]

I don't have any Axis on hand but was thinking about designing a 3D printable bullpup conversion for a friend. He should realize it's kind of impossible to design a stock conversion for something I don't have sitting in my office.

Does anyone know where I would find a CAD model or raw schematic of the factory stock mounting points?
I figure it would be a too-tall an order to have someone measure their gun for me and draw it out...

[Rosco]

Numrich might have some schematics.

[aaronllewellyn]

Numrich might have some schematics.

cool.

[aaronllewellyn]

Numrich might have some schematics.

Their schematics are just assemblies, I'm looking for the actual engineering documents, guess I'll just have to buy one and reverse engineer to know where the upper-to-stock mounting bolts are... :violin:

[Robinhood]

I'm kind of shocked someone doesn't have some of these sitting on their bench somewhere..........:behindsofa:

[short round]

Action Dia. 1.350''
Receiver mounting screws 4 25/32" between centers
Length of mag box 5 17/64"
Front of receiver to center of mounting screw 1"
Action length 6

Trigger Bracket adds 2" overall
Here are some measurements from my notes, good luck.

[aaronllewellyn]

Action Dia. 1.350''
Receiver mounting screws 4 25/32" between centers
Length of mag box 5 17/64"
Front of receiver to center of mounting screw 1"
Action length 6

Trigger Bracket adds 2" overall
Here are some measurements from my notes, good luck.

Cant really get much done with those measurements but thanks for the input.