Brass resizing after barrel swap

[rjtfroggy]

Turn the expander up in the die so that it does not reach the primer, size the cases then re adjust the de capping pin and go back to normal sizing of your brass.

[icker96]

Turn the expander up in the die so that it does not reach the primer, size the cases then re adjust the de capping pin and go back to normal sizing of your brass.

This is the route I went, and it seems to be working great. Thanks.

[J.Baker]

No need to totally remove the decapping/expander assembly. Instead just loosen the lock nut and slide the assembly up so that the bottom of the depriming pin is flush with the bottom of the die. This will prevent it from depriming while still allowing it to expand the case neck.

http://img.photobucket.com/albums/v632/MrFurious45833/Gun%20Stuff/DSC00845.jpg http://img.photobucket.com/albums/v632/MrFurious45833/Gun%20Stuff/DSC00846.jpg

Edit: Guess I should have looked at the replies on Pg 2 before posting.

[GaCop]

Full length size it with the decapping pin removed. +1!

[BillyTee]

For the record, I've deprimed plenty of live primers. You just go slow and be careful. Safety glasses wouldn't hurt either. Lol

So have I, just don't be ham fisted about it.