recoil lug

[tom338]

does anybody make a recoil lug for a savage accustock with the receiver detent on it that will fit a accustock without having to grind on it??

[Robinhood]

Are you looking for a thick one or factory piece?

Factory
http://www.midwayusa.com/product/1778238465/savage-arms-standard-shank-recoil-lug-10-110-series-with-accu-rail-steel

[tom338]

Looking for one like that with a detent on it so it fits into the receiver action and does not slip when tightening the barrel nut. I have seen some recoil lugs that have a square detent and have seen them with a pin type.

[LongRange]

Tom if you happen to find one pm me or post up where you got it....i have a 110BA ive been looking for a pinned or detent lug for for a long time.

[tom338]

I am wondering if Savage has a patent on it so nobody can make one. Would sure make changing barrels on accustocks easier.

[LongRange]

im not sure but yes it would make things easier.

[BillPa]

Looking for one like that with a detent on it so it fits into the receiver action and does not slip when tightening the barrel nut. I have seen some recoil lugs that have a square detent and have seen them with a pin type.

Just install a second pin 180 above the original so the lug can't move up-down or side -side. I made this to locate the hole for the second pin in ring after drilling the lug.
http://i50.tinypic.com/14aczk8.jpg


Both pins have a slight interference fit in the action so it stays attached and in position when a barrel is removed/installed.
http://i39.tinypic.com/ruqtl3.jpg

Bill