Axis aftermarket parts

[Dugga Boy]

Hello folks,
Please help out an old geezer. This question more than likely has been asked on the forum a zillion times. As far as aftermarket parts for the Axis rifles. Will Model 10 parts fit? I am mostly interested in barrels, stocks and bottom metal. Thanks Mike

[Rosco]

The Axis doesn't have nearly the amount of aftermarket support as the 110 Series but it is coming along. You can use the small shank 110 barrels, however the large shank will not work. The factory bottom metal will not interchange with the Axis, but the good news is you can now get CDI Metal which supports 10 round mags for the Boyd's stock.

See here

http://www.savageshooters.com/showthread.php?45007-Axis-CDI-Bottom-Metal

(http://www.savageshooters.com/showthread.php?45007-Axis-CDI-Bottom-Metal)
In addition, the Axis uses the same short action bolt heads that the 110 Series do but the Long action ones are not interchangeable. I am sure I forgot something!! But that's a good start.

[DrThunder88]

Plastic tab magazines used in the 1X/11X will also interchange. Two-piece scope mounts for round backs will fit the Axis but one-piece mounts are Axis-specific. Toward the end of the Stevens 200's life, some examples used the same trigger as the Axis. It's not a very common interchange to make, but the Rifle Basix trigger for the Axis (SAV-1) will also work on the 200 and 1X/11X rifles. Action screws maybe? The thread is the same, but I don't know about the length.

[Dugga Boy]

Thanks folks that is a starting point
Mike